-
Examine cement before using. If jellied, discard. Do not use primer/cleaner to thin out cement.
-
Square cut pipe and remove all dirt and burrs.
-
Check dry fit of pipe and fitting. Pipe should easily go into fitting 1/4 of the way.
-
Clean and prime pipe with Black Swan's ALL PURPOSE PRIMER/CLEANER. (Note: Do not use primer/cleaner when working with ABS systems.)
-
Apply thin coat of cement to fitting; avoid puddling inside.
-
Apply liberal coat of cement to pipe; leave no void areas. Enough cement must be used to completely fill any gaps in joint.
-
Assemble quickly while cement is still wet.
-
Push pipe into fitting using a 1/4 turning motion until pipe bottoms out.
-
Hold pipe and fitting together for 30 seconds; wipe off excess on collar.
-
Allow 15 minutes for good handling strength.
-
Allow joint 24 to 48 hours before applying pressure.
-
Stir frequently while using.
-
For 1/4 pint and 1/2 pint cans do not use applicator in can if pipe diameter exceed 1-1/4". For pint and quart cans do not use
applicator if pipe diameter exceeds 3".
Proper size of applicator should be 1/2 diameter of pipe.
-
Pressure test often so as to eliminate possible large failures.
-
Keep container tightly closed when not in use.
