|
SECTION I - GENERAL INFORMATION
|
Black
Swan Manufacturing Co.
4540 W. Thomas Street
Chicago, IL 60651-3318
Telephone No: 1-773-227-3700
Fax No: 1-773-227-3705 |
For chemical emergencies during
transportation only call
INFOTRAC
1-800-535-5053
24 hours per day - 7 days a week
|
| Date Prepared
01/01/08
|
Trade Name
Flange & Gasket |
|
SECTION II - HAZARDOUS INGREDIENTS
/ IDENTITY INFORMATION
|
HAZARDOUS
COMPONENTS CAS#
APPROX% ACGIH-TLV
OSHA-PEL
|
THIS PRODUCT
IS NOT CLASSIFIED AS HAZARDOUS ACCORDING WITH OSHA
1910.1200.
|
| *Title III
Section 313 Supplier Notification: this product contains
toxic chemicals subject to the reporting requirements
of Section 313 of the Emergency planning and community
Right-to-Know Act of 1966 and of 40CFR372. This information
must be included in all MSDS’s that are copied and
distributed for this material. |
|
SHIPPING INFORMATION
NOT HAZARDOUS FOR SHIPPING PURPOSES.
|
SPECIAL HAZARD DESIGNATIONS
| HEALTH |
0 |
0 |
0 - MINIMAL |
| FLAMMABILITY |
1 |
1 |
1 - SLIGHT |
| REACTIVITY |
0 |
0 |
2- MODERATE |
| PROTECTIVE |
|
|
3- SERIOUS |
| EQUIPMENT |
X |
|
4- SEVERE |
|
|
SECTION III - PHYSICAL DATA
|
| APPEARANCE
SOLID AMBER
|
ODOR
NEARLY ODORLESS
|
BOILING
POINT
N/A
|
| SPECIFIC
GRAVITY (H2O=1)
.85
|
VAPOR
PRESSURE (mm Hg.)
NIL
|
VOLATILE
BY VOLUME (%)
NIL
|
| VAPOR
DENSITY (AIR=1)
10+
|
EVAPORATION
RATE (BUAC=1)
N/A
|
SOLUBILITY
IN WATER
NIL
|
|
SECTION IV - FIRE AND EXPLOSION HAZARD
DATA
|
| FLASH
POINT ( METHOD USED) |
FLAMMABLE
LIMITS |
LEL |
UEL |
| 500°F MIN
P.M. |
(PERCENT BY
VOLUME) |
ND |
ND |
| FIRE EXTINGUISHING
MEDIA
CARBON DIOXIDE, FOAM, DRY CHEMICAL.
|
| SPECIAL
FIRE FIGHTING PROCEDURES
DO NOT USE WATER AS IT MAY BE INEFFECTIVE IN EXTINGUISHING
A FIRE INVOLVING THIS MATERIAL.
|
| UNUSUAL
FIRE AND EXPLOSION HAZARD
NONE
|
|
SECTION V - HEALTH HAZARD DATA
|
| PRIMARY ROUTES
OR ENTRY ______Inhalation __X___Skin
contact ______Eye contact ______Ingestion |
| EFFECT
OF OVEREXPOSURE
MIGHT IRRITATE SKIN.
|
| MEDICAL
CONDITIONS AGGRAVATED BY EXPOSURE
SKIN DISORDERS.
|
| EMERGENCY
AND FIRST AID PROCEDURES
SWALLOWING - NONE NECESSARY.
SKIN - NONE NECESSARY AS A SOLID. CONTACT WITH
MELTED PETROLATUM CAN CAUSE
THERMAL BURNS, FLUSH WITH WATER TO COOL AFFECTED
AREAS AND CONTACT A PHYSICIAN IMMEDIATELY.
INHALATION - REMOVE TO FRESH AIR, CALL A
PHYSICIAN.
EYES - FLUSH WITH WATER, CALL A PHYSICIAN.
|
|
SECTION VI - REACTIVITY
|
| STABILITY |
UNSTABLE |
|
CONDITIONS
TO AVOID |
| |
STABLE |
X |
EXCESS HEAT,
DIRECT FLAME. |
INCOMPATIBILITY (MATERIALS
TO AVOID)
STRONG OXIDIZERS. |
HAZARDOUS
DECOMPOSITION PRODUCTS
COMBUSTION WILL PRODUCE CARBON MONOXIDE AND OTHER
ASPHYXIANTS. |
HAZARDOUS
POLYMERIZATION |
MAY OCCUR |
|
CONDITIONS
TO AVOID |
| WILL NOT OCCUR |
X |
NONE KNOWN. |
|
SECTION VII - SPILL OR LEAK PROCEDURES
|
| STEPS
TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
RECOVER FREE SOLID. IF MOLTEN PARAFFIN SPILLED,
SOLDIFY AND RECOVER.
|
| WASTE
DISPOSAL METHOD
INCINERATE PER LOCAL, STATE AND FEDERAL REGULATIONS.
|
|
SECTION VIII - SPECIAL PROTECTION
INFORMATION
|
| RESPIRATORY
PROTECTION (Specify type)
N/A
|
| VENTILATION
N/A
|
| PROTECTIVE
GLOVES
N/A
|
EYE
PROTECTION
N/A
|
| OTHER
PROTECTIVE EQUIPMENT AND HYGIENIC PRACTICES
N/A
|
|
SECTION IX - SPECIAL PRECAUTIONS
|
| PRECAUTIONS
TO BE TAKEN IN HANDLING AND STORING
AVOID EXCESSIVE HEAT OR DIRECT FLAME.
|
| OTHER
PRECAUTIONS
WHEN DEALING WITH HOT MELTED PETROLATUM, SPECIAL
PRECAUTIONS PERTINENT TO YOUR OPERATION SHOULD BE
AS FOLLOWED. AS WITH ANY PETROLEUM HYDROCARBON, PERSONAL
HYGIENE IS IMPORTANT TO ASSURE THAT PROLONGED OR
REPEATED CONTACT IS MINIMIZED.
HANDS AND OTHER EXPOSED AREAS SHOULD BE WASHED THOROUGHLY
WITH SOAP AND WATER AFTER CONTACT, ESPECIALLY BEFORE
EATING AND OR SMOKING.
|
| This information
contained herein is based on data considered accurate.
However, no warranty is expressed or implied regarding
the accuracy of this data or the results to be
obtained from the use thereof. |
Print This Page