Print This Page

NO-HUB SEALANT

Material Safety Data Sheet

Information on this form is furnished solely for the purpose of compliance with the Occupational Safety and Health Act and shall not be used for any other purpose. Black Swan Manufacturing Co. urges the customers receiving this Material Safety Data Sheet to study it carefully to become aware of the hazards, if any, of the product involved. In the interest of safety, you should notify your employees, agents, and contractors of the information on the sheet.

SECTION I - GENERAL INFORMATION
Black Swan Manufacturing Co.
4540 W. Thomas Street
Chicago, IL 60651-3318
Telephone No: 1-773-227-3700
Fax No: 1-773-227-3705

For chemical emergencies during
transportation only call

INFOTRAC
1-800-535-5053
24 hours per day - 7 days a week
Date Prepared

01/01/08

 		Trade Name
NO-HUB SEALANT

SECTION II - HAZARDOUS INGREDIENTS / IDENTITY INFORMATION
HAZARDOUS COMPONENTS  CAS# APPROX%   ACGIH-TLV OSHA-PEL
ETHYL ALCOHOL  64-17-5 25-30 1000 ppm 1000 ppm
METHYL ALCOHOL 67-56-1 1-2 200 ppm 200 ppm
ETHYL ACETATE 141-78-6 <1 400 ppm 400 ppm
ACETONE 67--64-1 35-45 500 ppm 1000 ppm
*Title III Section 313 Supplier Notification: this product contains toxic chemicals subject to the reporting requirements of Section 313 of the Emergency planning and community Right-to-Know Act of 1966 and of 40CFR372. This information must be included in all MSDS’s that are copied and distributed for this material.

SHIPPING INFORMATION

CONSUMER COMMODITY ORM-D

SPECIAL HAZARD DESIGNATIONS

HMIS HAZARD RATING
HEALTH 1 0 - MINIMAL
FLAMMABILITY 3 1- SLIGHT
REACTIVITY 0 2- MODERATE
PROTECTIVE 3- SERIOUS
EQUIPMENT B 4- SEVERE

SECTION III - PHYSICAL DATA
APPEARANCE

AMBER VISCOUS LIQUID

 		ODOR

CHARACTERISTIC SOLVENT ODOR

 		BOILING POINT

ABOUT 170ºF
SPECIFIC GRAVITY (H2O=1)

APPROX - 0.7

 		VAPOR PRESSURE (mm Hg.)

N/A

 		VOLATILE BY VOLUME (%)

70
VAPOR DENSITY (AIR=1)

>1

 EVAPORATION RATE (BUAC=1)

>1

 		SOLUBILITY IN WATER

INSOLUBLE

SECTION IV - FIRE AND EXPLOSION HAZARD DATA
FLASH POINT ( METHOD USED) FLAMMABLE LIMITS LEL UEL

65ºF (T.C.C.)

 (PERCENT BY VOLUME) 0.9% 7.0%
FIRE EXTINGUISHING MEDIA

FOAM, CARBON DIOXIDE OR DRY CHEMICALS

SPECIAL FIRE FIGHTING PROCEDURES

WEAR SELF CONTAINED BREATHING APPARATUS AND PROTECTIVE CLOTHING

UNUSUAL FIRE AND EXPLOSION HAZARD

VAPORS MAY TRAVEL CONSIDERABLE DISTANCE TO A SOURCE OF IGNITION AND FLASH BACK.

SECTION V - HEALTH HAZARD DATA
PRIMARY ROUTES OR ENTRY _X_Inhalation __X___Skin contact ___X___Eye contact ___X__Ingestion
EFFECT OF OVEREXPOSURE

INHALATION: IT IS A RESPIRATORY TRACT AND ANESTHETIC AND OVER EXPOSURE CAN CAUSE CENTRAL NERVOUS SYSTEM DEPRESSION. 

SKIN: MAY CAUSE SKIN IRRITATION AND DERMATITIS UPON PROLONGED OR REPEATED CONTACT.

EYES: MAY BE AN IRRITANT.

INGESTION: VOMITING 
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE

Any pre-existing heart or skin condition or an impaired lung function.
EMERGENCY AND FIRST AID PROCEDURES

EYES: FLUSH WITH LARGE AMOUNT OF WATER FOR AT LEAST 15 MINUTES. CONSULT PHYSICIAN.

SKIN CONTACT: WASH THOROUGHLY WITH SOAP AND WATER.

INHALATION: REMOVE TO FRESH AIR.  IF BREATHING STOPS, BEGIN ARTIFICIAL RESPIRATION AND CONSULT PHYSICIAN.

SECTION VI - REACTIVITY
STABILITY UNSTABLE   CONDITIONS TO AVOID
  STABLE X SPARKS, OPEN FLAMES, HOT SURFACES AND STRONG OXIDIZING AGENTS.
INCOMPATIBILITY (MATERIALS TO AVOID)
STRONG OXIDIZING AGENTS, STRONG ACIDS.
HAZARDOUS DECOMPOSITION PRODUCTS
CARBON MONOXIDE AND DIOXIDE
HAZARDOUS
POLYMERIZATION		 MAY OCCUR   CONDITIONS TO AVOID
WILL NOT OCCUR X

SPARKS, OPEN FLAMES OR HOT SURFACES

SECTION VII - SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED

ABSORB ON SUITABLE INERT MATERIAL. REMOVE ALL SOURCES OF IGNITION.
WASTE DISPOSAL METHOD

DISPOSE IN ACCORDANCE WITH APPLICABLE LOCAL, STATE AND FEDERAL REGULATIONS.

SECTION VIII - SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION (Specify type)

USE A NIOSH/MSHA APPROVED CARTRIDGE RESPIRATOR UNLESS AIR MONITORING DEMONSTRATES THAT VAPOR/MIST LEVELS ARE WITHIN APPLICABLE LIMITS.
VENTILATION

MECHANICAL
PROTECTIVE GLOVES

IMPERMEABLE GLOVES RECOMMENDED

 		EYE PROTECTION

SAFETY GLASSES WITH SIDE SHIELDS OR CHEMICAL GOGGLES.
OTHER PROTECTIVE EQUIPMENT AND HYGIENIC PRACTICES

AVAILABILITY OF EYE WASHES AND SAFETY SHOWERS IS RECOMMENDED.

SECTION IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING

KEEP AND STORE IN A COOL, DRY PLACE FROM SOURCES OF IGNITION. GROUND DURING TRANSFER.

OTHER PRECAUTIONS

REPEATED AND PROLONGED OVEREXPOSURE TO SOLVENTS MAY CAUSE BRAIN AND NERVOUS SYSTEM DAMAGE.  CONCENTRATING AND INHALING THE CONTENTS MAY BE HARMFUL OR FATAL.
This information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of this data or the results to be obtained from the use thereof.